Description
This Current Feedback Monitor Cable will permit current sampling and can be used with any BIOPAC Stimulator for current verification.
- Feedback constant: 1 V = 10 ma
- Male Touchproof and Female Touchproof with 100 ohm 1% MF 1 Watt resistor in series between leads
- 3.5 mm mono phone plug cable, 2 m (6.6″)
CBLCFMA is recommended for use with any voltage stimulator.
To isolate CBLCFMA output if other electrical connections are made (for instance, for ECG, EDA, EMG, etc.):
MP200/MP200: connect CBLCFMA through INISOA to AMI100D or HLT100C
MP36/MP36R: connect CBLCFMA through SS70LA and BSLCBL6

Micro Electrode Amplifier
Platinum Level Support Package
EEG Caps for CAP100C
Differential Pressure Transducers
Noninvasive Blood Pressure Module
Electromyogram Amplifier
Tail Heating Units
Electrode Leads - BioNomadix Wireless
Special Electrode Lead Clips
Micro Pressure Measurement System
Wireless Heel/Toe Strike Transducer - BioNomadix
T-valves
Heated Pneumotachs
Electrobioimpedance Amplifier
Skin Temperature Amplifier
Stimulator Interface Cables
EPOCH Transmitter Activation Utility
Ribbon Cables
Face Mask, Adult, w/T-valve
Calibration Cables
Subject Response - DSub9
Cable: 3.5 mm to 2 x tinned wire 